Kodak Q-60 color input target

From: Burt Altman (baltman@MAILER.FSU.EDU)
Date: Wed May 09 2001 - 14:26:22 CDT

  • Next message: Simon Tanner: "Metadata Engine - Newsletter now available" 

    Message-Id: <200105091942.MAA23174@dns.ccit.arizona.edu>
Date:         Wed, 9 May 2001 15:26:22 -0400
From: Burt Altman <mailto:baltman@MAILER.FSU.EDU>
Subject:      Kodak Q-60 color input target
To: mailto:IMAGELIB@LISTSERV.ARIZONA.EDU

    <pre> Is there anyone on the ImageLib list familiar with this type of color target and its use in calibrating Hewlett Packard scanners? We've just acquired one to use for calibration by using the HP 6100C to scan this target, and have not been successful.

    We're using HP Deskscan II scanning software. Every time we try to scan the target we get the message, "Sorry, could not calibrate. Insure the target is straight and positioned correctly."

    When we take steps to insure the target is positioned correctly, we receive an error message, "Could not calibrate. The target size has changed."

    We've contacted Hewlett Packard and Kodak about these issues, but neither of them have been very helpful.

    I wonder if this problem is specific to HP?

    Does anyone have suggestions?

    Thanks, Burt

    Burt Altman, CA Pepper Librarian and Archivist Claude Pepper Library 636 West Call Street Florida State University Tallahassee, FL 32306-1123
    (850) 644-9305 Fax: (850) 644-9303

    </pre>

    This archive was generated by hypermail 2b29 : Wed May 09 2001 - 14:44:59 CDT